Tell me, please, because I am desperate to fix it myself.
The situation is this:
The device is ABOUT.
like the latest firmware 1.05.
Set to normal mode UP-2 or 3 (tried and duplex)
(use without speaker)
The sensitivity of the set and 1 and 5 and 10 and 20.
Every day for months. never worked
That is, the number of positives 0.
When checking the sensitivity via menu - responds to eye movement (emulation duplex mode). But the dream never noticed the eye movement.
I am ashamed to think can I have them not move when dreaming
Tried a finger moving near the sensors - also squeaks.
But repeatedly noticed this: Wake up, quietly not doing anything, just "wiggling" eyes closed, wiggling as ogogo! - wait 10 minutes or more - any attempt to give the flash. Check mode shows UP. Ie would have to react.
A couple of times was that I woke up, took off the mask, but forgot to turn it off - that it then suddenly started to blink but apart from me, of course.
To permitactive the batteries and reset the default tried.
What other experiences to understand what it is advise?
PS in the description it is very unclear and contradictory written about the installation of cosmicality. What position the most sensitive 1 or 20?
Update: found this thread here:
http://www.mindmachine.ru/viewtopic.php?t=2733
will check all again the points - otpishu.
the mask will try to glue on the double sided tape in place advertsie - could be better.
Dream Stalker Pro wakes
Re: Dream Stalker Pro wakes
Regarding triggers
-
- Posts:813
- Joined:Sun Dec 16, 2007 12:24
- Location:Москва
- Has thanked: 6 times
- Been thanked: 18 times
Re: Dream Stalker Pro wakes
The theme author did not write about their experiments once performed is written here: http://www.mindmachine.ru/viewtopic.php?t=2733. If anyone has any problems or doubts about the correct operation of the appliance, follow the referenced method of testing the motion sensor eye. This method actually tests the entire cycle of operation of the device. And remember, if the problem is starred, then you'll obviously not enough just to make the program restart mode (SEtd) to return settings to normal .