Configuring the Rem-dreamer

Post by **Владимир Никонов 2** » Mon Oct 01, 2007 17:00

I propose to discuss the nuances of the instrument settings.

Post by **Владимир Никонов 2** » Mon Oct 01, 2007 17:07

How to check the device:
For simple try in that order.
0. Remove and insert the batteries(reset all settings).
1. Then all the levers down and press the button you hear the tone "BEEP" - the unit is powered on.
2. Then all the levers up, and then 2 or 3(this choice of mode) down - click. Is flash. Attention: if, instead flash "BEEP" tap again on the button.
3. All switches up. Click 1 time on the button - you will hear a "BEEP" - included a delay of 10 min.
4. Wait 10 minutes, after 10 minutes, the device will flash. All of it works and tracks the movement of your eyes.

On paragraph 3, how many times the button presses, so there will be a delay in turning on. Each press is 10 minutes.

I recommend you to configure the device, but not put it on immediately. To set up and put under the bed. And wear better in the morning for a few hours before you get up.

зс · Post by зс » Tue Oct 02, 2007 10:39

Thank you so much! simple and clear ! and then I have this damn manual for the third night nichev comes out , I hope that this time things would be different. Thank you!

Влад · Post by **Влад** » Wed Oct 24, 2007 8:00

Никонов Владимир wrote:How to check the device:
For simple try in that order.
0. Remove and insert the batteries(reset all settings).
1. Then all the levers down and press the button you hear the tone "BEEP" - the unit is powered on.

I have a BEEP only on second click appears after you insert the batteries. After the first button once blinking diodes. switches down(ON) so I always press 2 times the button after insertion of batteries.

Post by **Владимир Никонов 2** » Thu Oct 25, 2007 1:46

I have a BEEP only on second click appears - so be it. This is the caveat.

Коломбо · Post by **Коломбо** » Thu Dec 13, 2007 12:17

Write that to set the idle time necessary if the device is programmed to track the REM?? Where the inclusion of the REM track after selecting the timeout?

Post by **Владимир Никонов 2** » Thu Dec 13, 2007 13:24

where the inclusion of the REM track after selecting the timeout?

To set the time is the choice of the mode of operation of the device. Just above this topic is described in more detail.

Коломбо · Post by **Коломбо** » Sun Dec 16, 2007 1:17

Anyone know how to work the sensitivity? No wonder that the gradation made up to 20, but the default 5.
Put 10, I will try and I for example sent a series of signals even when I sleep not seen, but asleep - it is not clear what worked.

Sedna has to the third night of habituation/testing dimera.
Try normal mode changed to manual settings: light 2/6, sensitivity 10.

Кореш · Post by **Кореш** » Fri Nov 28, 2008 0:22

At least someone still uses RemDreamer ? Or everything is already REM Stalkers become ?

I still from time to time the sounds of your RD...but remade it a little...

алекс123 · Post by **алекс123** » Fri Nov 28, 2008 1:20

I yuzayu, and what you altered ?