Question about Nova Pro 100

Стентани
Posts:5
Joined:Fri Oct 16, 2015 15:30
Re: a question about the Nova Pro 100

Post by Стентани » Sun Nov 01, 2015 1:45

Thank you!!!

Анталия
Posts:4
Joined:Sat Jun 27, 2015 22:34
Been thanked: 1 time

Re: a question about the Nova Pro 100

Post by Анталия » Thu Nov 05, 2015 18:29

Hello colleagues, The name of the theme is tempting, but for some reason, here only the technical stuff discussed. It would be more interesting (in my opinion) experiences in sessions to share. Or stories about experimeted with frequency on the Nova Pro.

User avatar
ЛИЛИЯ-Р
Posts:3002
Joined:Thu Oct 11, 2007 21:25
Location:Москва
Has thanked: 478 times
Been thanked: 264 times

Re: a question about the Nova Pro 100

Post by ЛИЛИЯ-Р » Thu Nov 05, 2015 19:45

Antalya Here : http://www.mindmachine.ru/forum/viewforum.php?f=13 very much discussion sessions and not only.

Дмитрий Дмитрий
Posts:5
Joined:Tue Dec 01, 2015 15:18
Has thanked: 3 times

Re: a question about the Nova Pro 100

Post by Дмитрий Дмитрий » Tue Dec 01, 2015 15:23

Hello! I also have a question on the Nova Pro 100. Tell me, is there any user manual for careful operation? Specifically, I am interested in the battery. How should you apply? If it is energy, whether still during use of the device to plug it in? Or is it optional? I know next to nothing about batteries, but I've heard that some so do not want to, supposedly leads to a rapid wear.

User avatar
ЛИЛИЯ-Р
Posts:3002
Joined:Thu Oct 11, 2007 21:25
Location:Москва
Has thanked: 478 times
Been thanked: 264 times

Re: a question about the Nova Pro 100

Post by ЛИЛИЯ-Р » Tue Dec 01, 2015 15:29

Dmitry Dmitry Continuously not worth it, only if the battery will show 3 flashing dots on the display .

Дмитрий Дмитрий
Posts:5
Joined:Tue Dec 01, 2015 15:18
Has thanked: 3 times

Re: a question about the Nova Pro 100

Post by Дмитрий Дмитрий » Tue Dec 01, 2015 15:31

Thank you)

Андрей Патрушев
Автор сайта
Posts:10238
Joined:Tue May 30, 2006 20:17
Location:Екатеринбург
Has thanked: 134 times
Been thanked: 556 times
Contact:

Re: a question about the Nova Pro 100

Post by Андрей Патрушев » Tue Dec 01, 2015 17:50

Dmitry Dmitry
Nova Pro 100 acid battery, which does not like full discharge. I have 10 years this machine almost permanently plugged in before I replaced the battery...

User avatar
Аларик
Posts:38
Joined:Fri Nov 12, 2010 12:18
Location:г. Екатеринбург

Re: a question about the Nova Pro 100

Post by Аларик » Tue Dec 01, 2015 18:35

Hello!

Four years use MM dimensions Nova Pro 100. In the last two years, I use MM often and not occasionally, but periodically I try to fully charge the battery.

After the last charging of the battery, pay attention to the following phenomenon immediately after turning on the mechanical power button of the device, periodically began to glow and slightly to blink the LEDs on the glasses, before the moment of choice and enable the required session. LEDs also began to react glow on strengthening and reducing the adjustment as volume and brightness points.

Most interesting is that after choosing my desired session and actually pressing the Play button, the LEDs on the glasses turns off and randomly flash while there is a countdown of 10 seconds. interval to the start of the session, and then starts playing the actual session. At the end of the game session, LEDs also do not glow while off label End, but after pressing the button Play, they again begin to glow slightly and weakly perepisyvatsya.
Previously, such kind of defect is not observed. Ie the LEDs on the glasses themselves do not light up and does not respond to buttons and wheels control, has not yet started playback of the session after 10 seconds. the countdown on the display.

Glasses now use a standard blue-red. Tried to turn on and again to turn off the machine, rearranged the plugs, points and headphone connectors on the redundant back and forth, spinning the wheels amplify the sound and brightness, switched on the glasses modes CC–LR back and forth, the LEDs wink hard, even before the selection and play, I need session.

What could be the problem?

Андрей Патрушев
Автор сайта
Posts:10238
Joined:Tue May 30, 2006 20:17
Location:Екатеринбург
Has thanked: 134 times
Been thanked: 556 times
Contact:

Re: a question about the Nova Pro 100

Post by Андрей Патрушев » Tue Dec 01, 2015 19:15

Alaric
Nothing I can tell. The first time I heard about this. :?

User avatar
Аларик
Posts:38
Joined:Fri Nov 12, 2010 12:18
Location:г. Екатеринбург

Re: a question about the Nova Pro 100

Post by Аларик » Wed Dec 02, 2015 16:55

Andrey Vadimovich, thanks for the response.
And besides You, of specialists technicians here? :)

Yesterday, method scientific, I found that the problem is related to power management or battery. Something, somewhere was "to short" (a device kept in a special plastic box and not dropping, the nails were not nailed).

Specifically, if you switch the unit on from the battery, the led starts blinking before the start of the session, but at the moment 10 sec. reference but they don't blink and then session lost like correctly. Again, one has only to go into selection mode sessions (Select), again they themselves begin to blink.

So, the most interesting that yesterday I found that when I connected the device through the power supply supplied and turned on, that spontaneous blinking was not as should behave a device. But only if the power supply was connected to the network, and easily connect the plug in Power connector to MM, without a supply of mains voltage, again could not solve the problem – the LEDs blink on the glasses themselves (i.e. the problem probably is not in the Power connector).
Also checked the glasses and headphones, put on other glasses and with a different cord, still led by themselves, wink.

Hence, I did quite amateurish, but a reasonable conclusion or something powered by the internal battery or some electronics (a chip) is responsible for administering the supply lines.

PS.: There is still a suspicion that I still "put" the battery. There was a time when I completely forgot about MM, and she was a few months stored with almost discharged battery. But, then, how is it connected, because the "dead" battery can not by itself provide signals to the glasses?

User avatar
ЛИЛИЯ-Р
Posts:3002
Joined:Thu Oct 11, 2007 21:25
Location:Москва
Has thanked: 478 times
Been thanked: 264 times

Re: a question about the Nova Pro 100

Post by ЛИЛИЯ-Р » Wed Dec 02, 2015 17:04

Alaric If you enable MM Nova Pro you have the points already inserted into the connector , the glasses react to the flash but not steady light, and off. When you launch a session directly, the points reproduce the gate.signals session.

Андрей Патрушев
Автор сайта
Posts:10238
Joined:Tue May 30, 2006 20:17
Location:Екатеринбург
Has thanked: 134 times
Been thanked: 556 times
Contact:

Re: a question about the Nova Pro 100

Post by Андрей Патрушев » Wed Dec 02, 2015 17:59

Alaric
Probably, if everything works, then there is no need to bother... :wink:

User avatar
ЛИЛИЯ-Р
Posts:3002
Joined:Thu Oct 11, 2007 21:25
Location:Москва
Has thanked: 478 times
Been thanked: 264 times

Re: a question about the Nova Pro 100

Post by ЛИЛИЯ-Р » Wed Dec 02, 2015 19:06

Аларик wrote:PS.: There is still a suspicion that I still "put" the battery. There was a time when I completely forgot about MM, and she was a few months stored with almost discharged battery. But, then, how is it connected, because the "dead" battery can not by itself provide signals to the glasses?
If the problem is in the battery , you can replace it, the office is available.

User avatar
Аларик
Posts:38
Joined:Fri Nov 12, 2010 12:18
Location:г. Екатеринбург

Re: a question about the Nova Pro 100

Post by Аларик » Wed Dec 02, 2015 23:37

Андрей Патрушев wrote:Alaric
Probably, if everything works, then there is no need to bother... :wink:
Yes, but using it correctly?
I can't know what session this correctly played. Yes, there's something flashing, and noise in the headphones, but how to check that now MM will signal the desired quality?

User avatar
Аларик
Posts:38
Joined:Fri Nov 12, 2010 12:18
Location:г. Екатеринбург

Re: a question about the Nova Pro 100

Post by Аларик » Wed Dec 02, 2015 23:46

ЛИЛИЯ-Р wrote:Alaric If you enable MM Nova Pro you have the points already inserted into the connector , the glasses react to the flash but not steady light, and off. When you launch a session directly, the points reproduce the gate.signals session.
About quick flash when on. and off. I know. This is different.
Is there a possibility to post a video?

About the battery, not sure if he normally works.
Open the box, look stuffing: do not run down if sitting parts, not burned if the tracks on the circuit Board and is not swollen whether the capacitors, etc., can measure the data on the battery contacts conventional electromaster.

Could you tell me what parameters should give a normal working battery?

Андрей Патрушев
Автор сайта
Posts:10238
Joined:Tue May 30, 2006 20:17
Location:Екатеринбург
Has thanked: 134 times
Been thanked: 556 times
Contact:

Re: a question about the Nova Pro 100

Post by Андрей Патрушев » Thu Dec 03, 2015 9:53

Аларик wrote:Yeah, but is working correctly?
I can't know what session this correctly played. Yes, there's something flashing, and noise in the headphones, but how to check that now MM will signal the desired quality?
I am more than confident that the quality of signals is not affected. :)

Post Reply