Forum

And I think I'll start another topic, I thought - and began.

But there is an idea to try to do lens on Sacred Standards. But what are they? There are two types Sacred Standards

• linear
• ring

if you do ring, then the lens must be closed. It may still linear?
I scratched turnip, and decided that the lens is hardly a straight line, the lens is flat caduceus, i.e. it is necessary to do kalavai standards
According to the question of how to close. Again scratched turnip, and decided to do so:

the perimeter of the outer ring = 1/2 Sacral Measurements
Length of both halves of the spiral = 3 Sacral Measurements
Total: 3.5 Sacral Measurements
The length of the spiral was calculated by following formulae: http://www.intmath.com/blog/mathematics ... piral-6595
Integral calculator: http://www.integral-calculator.com/#
The estimated length of polypyrole: 783.4656264357319 mm which roughly coincided with 1.5 Sacral Measurements: 784.9
Criticize as compacted, give a print...

when looking appeared yellow rays, or rather as if the "radii" of about a dozen
then a little visual geometry was distorted - the wave is small then the centre grabs like surround thing

remeasure, give to the print probably
it's not fast, a month somewhere....

in fact, the theme interesting, you can try to make the lens minimum line width, it will give a greater length, that's interesting.
in fact, you can try to do layered, and close the layers sequentially, in General, have something to think about

triskelion I decided not to do, there is not so simple...

Ahem... ready.