Sitting watching the video, as the Americans shakes Moebius: hooked wire over a nail the other end in a drill and counter-clockwise. A couple of minutes and you're done.
Look for more then.
The knots are due to the fact that the cable is badly stretched. On the opposite side of the drill on the two wire loop. If each loop to make the interference, the nodes will not. They appear when these two loops to hook onto one hook. And yet, before winding, you need to flatten the wire. I use a soft flannel. To smooth from the drill to the eyelets. Therefore, the desired preload on each, the distance between the eyes and a drill for a few millimeters different.ИгорьС wrote:but still there are nodes
Ie if you catch the 2 hooks should be better? I tried 2 springs to cling to, but probably should be more tight. These have started to curl.Ланцелот wrote:The knots are due to the fact that the cable is badly stretched. On the opposite side of the drill on the two wire loop. If each loop to make the interference, the nodes will not. They appear when these two loops to hook onto one hook.ИгорьС wrote:but still there are nodes
-About insulation strength totally agree with You. Winding short circuit is not Gud...Ланцелот wrote:Igors
Plastic insulation rigid, not solko extra turns in different places. The insulation should be soft but durable. Therefore, the better the Polish.



Therefore, we need a third. it provides a preload instead of springs. Although you can try to throw a loop on the springs, smooth wire flannel, to remove loops in the springs manually to ensure tightness. But in this case, the 45 degree angle is difficult to obtain. I have never worked. Here you need to find the wire.I tried 2 springs to cling to, but probably should be more tight.
-I knowЛанцелот wrote:Swami Dopado Looks beautiful Moebius. But... it is Desirable that the twist angle was close to 45 degrees in the photo, to the eye 60. The circumference should be three turns on a photo or 2, or a little more, but certainly not three. At Mobius, if you twist 45 degrees, then the windings have to look almost in the center of the ring. In the photo they do not look into the center, and to mine the diameter at 1/3 and 2/3.
Judging by Logan's not quite right.
Flat or convex? And how it is combined with the crystal, if possible a photo.Свами Доупаду wrote:and coil the birthplace of Marco - Rodin Coil
- A classic "donut hole" . photos can not bring ,alas..Ланцелот wrote:Flat or convex? And how it is combined with the crystal, if possible a photo.Свами Доупаду wrote:and coil the birthplace of Marco - Rodin Coil
After removal from the prototyping Board, I have all the coils of Logan become in the form of 12 petal Lotus.Свами Доупаду wrote:and that the curved coil home ?

АлексЦБР wrote:Good day.
Please tell me, in terms of efficiency (power) is a big difference between a quartz crystal and a simple piece of quartz? If the same size, approximately. Fill in a simple organit, without coil.
Edward, you make m this way and that, experiment and tell us... okay?Эдуард wrote:is it worth doing or no?
what sign would you recommend?
