Radionic devices

[Добрый]

[Обсидиан]

Good

knobs on the resistors, it is desirable to choose larger

Here, in principle, what are the main errors:
1. The handle is located above "touchpad", it would be better to place them to the left of him, that his hand lay gently on one plate, the other on the handle, and nothing would interfere with each other;
2. The handles are located close to each other, it is inconvenient when they are Curling, and there is no place under the scale. Large here already, in principle, will fail to install. (Well, and clean IMHO, if done first Radionics, it is better to do three resistors, and when it becomes clear how to set and develop into "sensitivity", you can still punch, it is better place to leave in advance or to punch once and then connect.)

The same plate once very close to each other, would be better if the distance between them mm 5-10 to make, especially since the area allows. And the insides could be arranged not only on the inner side of the top panel, where to give more space for the resistors, and on the side and bottom cover, if any. Generally look quite harsh, reminiscent of a good Soviet electronics, you'd something to cover, or the same aerosole paint to go.) Good, shall describe the functionality?

For the manufacture of shells are well-suited to kitchen cutting boards.

And I still any body was looking for!))

[Владимирвввв]

In Russia, 2017 food will begin to irradiate electrons.
A link to Yandex news https://news.yandex.ru/yandsearch?cl4ur ... &rpt=story
This so-called cold pasteurization, irradiation with electron products.Interestingly, the effect will be positive in the products for health as when the saturation of the electrons of water that AFP become negative, and air ionizer Chizhevsky - there are also electrons, like or not?

[Добрый]

Radionic ready,lay out the final Assembly,were done according to the scheme(bottom)we only have 5 variable resistor,the output plate stainless steel.and ground without ballast.The ammeter on the alternator output.

[аВАЛОН]

in the diagram above, one of the elements of this ground ballast cylinder organic that has three challenge, explain who knows what this thing is,what is the role and what the correct functionality of its manufacture understand that this coil kaduce bathed in organic and on top of which the copper plate or cylinder soon, thanks in advance

[XUPOH]

in the diagram above, one of the elements of this ground ballast cylinder organic

The primary source of this node, which is a cylinder orgonite high density in a short copper tube that is described as optional. Its purpose is to feed the device distracted AMY. The device is quite functional without it, it is only necessary to connect the "ground" end of the secondary coil with the negative terminal of the generator of a meander (in their language of Zapper).